Tuya Smart Life-Hub ZigBee of 3 bands

[mengi]

Hello, I have bought the following device "Zigbee" (Tuya Smart Life-Hub ZigBee of 3 bands, wireless switch for smart home), and eedomus recognizes it, the 3 buttons, but when I press, I have put several values, but it only recognizes me pressing "0 = off"

Does anyone know if you can put other values that recognize it, or just not supported?

Thanks.

[Kimax57]

You don't have hidden values?? if you not other values. check this.

when you add the remote control, do you have sensor or switch ?? I have Xiaomi switches, it works as a sensor not as a switch. During the installation of the switch. "module is controllable?" click on no. add in sensor. you will have the values. In zigbee all the switches work as a sensor and then I do a virtual one.

[mengi]

Thanks for your answer.

I have deleted the sensor and created it again.

It has been created for me as a sensor, and it has 4 values, but every time I press, it always only recognizes "off", and I don't know how I could make it recognize the rest of the values when pressing.

I do not know if, as you say, it could be valid, since when pressing, it always recognizes only the "off"

Inclusion

Mando.jpg (67.97 Kio) Consulté 1943 fois

Valores

Valores.jpg (32.36 Kio) Consulté 1943 fois

log

log.jpg (53.97 Kio) Consulté 1943 fois